Motorcycle injection claimed minimal maintenance. Especially the fuel gas supply component. Because the flow of fuel gas to the kitchen runways ranging from petrol pumps, nozzles, injekor, trothle body Until the ignition timing is set Eletronic Controle Module (ECM). So no need to disassemble the carburetor-tidal range.
Even so, to maintain performance, not just any gasoline consumption. For poor quality and dirty water filters make the engine rev hard langsam, mbrebet to Erode components.
Causes of symptoms That there are five factors. The first and most vital Pls Often gasoline consumption is low quality. Moreover, rarely cleaned air filter every 4.000 km. Second, if ignored usually a lot of sediment in the tank. It clogs the filters and cans affect the gas pumps and injector nozzles.
Third, if the nozzles and injector was seized with dirt, not just the flow choked up, but four injector hole diameter of 0153 mm Could Be eroded. As a result, the supply of heavy fuel and not mengabut.
Factors to-4 Pls Trotthle Position Sensor (TPS) in the throtle body Buried in the dirt due to fuel quality or dirty air filter. As a result, the sensor signals to the ECM Tough Love how the degree of butterfly valves, to suit the flow of gasoline. Langsam so not okay.
Last or the 5th if there is a socket or connector cable is loose or dislodged. Good idea to always check its condition.
0 comments:
Post a Comment