Recognizing the Bald Tires

Beware of baldness hair, surely you would be very disturbing appearance. But if the vehicle tires bald, in addition to damaging the appearance, also lives at stake. If if you do not frequently check the condition of the tires thoroughly one-one you missed in the middle of the road.

Tires are a vital component if the vehicle going bald could endanger your life, imagine if the car lost control due to tire blow-out loss traksinya or in the middle jalan.Oleh therefore avoid the bald tires on your vehicle

Tire manufacturer has provided a special mark on each product. Usefulness of these markers is as an indicator of how worn out the tires of vehicles or so-called Tread Wear Indicator. These indicators are shaped lump that is in the tire grooves as shown in the picture.

The more widely used then the surface of the tire will be more depleted eroded by road. Well if you tire surface is lined with Tread Wear Indicator means the tire is already out of useful life.

But you also must understand the nature of the erosion on the surface of the tire. Usually erosion on the front tires are different from the rear tires. Especially in the vehicle with the driver in front (front wheel drive). To neutralize this you are advised to swap the front wheels with rear wheel every 10,000 km mileage.

There are also hair loss caused by faulty tires wheel alignment. Ban will be eroded only on one side only. This is caused by because lack of harmony between the right and left front wheels so that the distribution of load on the tire surface is uneven. When this happens you will usually feel your steering wheel as likely to walk to the left or right. If this is detected you must bring your vehicle to the service center or your garage to service spooring.

Make a check on your tires about once a month to avoid things that are not desired. If you are visiting your garage whether it's for just an oil change or routine care alone, do not forget to ask all check your tire condition. Who knows just technicians found signs of wear and tear is missed by your own.

Injection motor problems due to bad fuel

Motorcycle injection claimed minimal maintenance. Especially the fuel gas supply component. Because the flow of fuel gas to the kitchen runways ranging from petrol pumps, nozzles, injekor, trothle body Until the ignition timing is set Eletronic Controle Module (ECM). So no need to disassemble the carburetor-tidal range.

Even so, to maintain performance, not just any gasoline consumption. For poor quality and dirty water filters make the engine rev hard langsam, mbrebet to Erode components.

Causes of symptoms That there are five factors. The first and most vital Pls Often gasoline consumption is low quality. Moreover, rarely cleaned air filter every 4.000 km. Second, if ignored usually a lot of sediment in the tank. It clogs the filters and cans affect the gas pumps and injector nozzles.

Third, if the nozzles and injector was seized with dirt, not just the flow choked up, but four injector hole diameter of 0153 mm Could Be eroded. As a result, the supply of heavy fuel and not mengabut.

Factors to-4 Pls Trotthle Position Sensor (TPS) in the throtle body Buried in the dirt due to fuel quality or dirty air filter. As a result, the sensor signals to the ECM Tough Love how the degree of butterfly valves, to suit the flow of gasoline. Langsam so not okay.

Last or the 5th if there is a socket or connector cable is loose or dislodged. Good idea to always check its condition.

Detecting Damage of Car Automatic Transmission

Automatic transmission on the car more vulnerable to damage than the manual transmission. That is because matic transmission is more complex. Here is the easy way as an early indication to check the condition of an automobile automatic transmission.

1. Check the condition of oil / lubricant transmission. Turn on the machine and check the transmission oil dipstick. When the oil is brown-black, and seen the iron powder is mixed in the oil means the condition is not good. It indicates that rough friction between the components therein. 
2. Testdrive and watch carefully. Move the transmission of such PRND first road going from the parking position. Do it slowly and watch carefully every movement. If you feel the beat of an excess or a slightly rough voice that has become a warning. When the car is already adopted a system of automatic transmission CVT (Continuous Variable Transmission) seharsnya movement feels very smooth.
3. Inspection by a professional workshop. If possible, take it to professional workshops. Even the available number of workshops that specialize in the service of checking and repair automatic transmissions. Certainly more accurate inspection results.